
Starter PackFor all hard and gas permeable contact lenses TOTALCARE is a simple and convenient system for the rare of hard & gas permeable contact lenses. The TOTALCARE system consists of the following components which may be purchased separately:
Daily careAlways wash and dry your hands thoroughly before handling your contact lenses. CleaningRemove the left lens from your eye and place on the palm of your hand. Place 2-3 drops of TOTALCARE Daily Cleaner on each lens surface and rub for 15-20 seconds with your finger. Rinse the lens thoroughly with TOTALCARE solution or sterile saline to remove all traces of cleaner. Place the lens in the holder of the left cap (L) and close the lens case with this cap. Fill the lens case with TOTALCARE solution. Ensure that the lens case is completely filled to the top. Repeat this procedure with ; the right contact lens. DisinfectingAllow your lenses to soak in TOTALCARE solution for at least 6 hours (overnight) to ensure thorough disinfection. Store the lenses ln the unopened lens case until ready to wear. Rinse your lenses with TOTALCARE solution and insert them into your eyes. Discard used solution and rinse the lens case with TOTALCARE solution and allow to air dry. Note: Your lenses may be stored in the unopened lens case for a maximum of 30 days. If they are stored for longer periods of time, disinfect again before inserting your lenses. WettingFor wetting, place one or two drops of TOTALCARE solution on the inner surface of each contact lens before inserting into your eye. Protein RemovalYour optician will advise it protein removal Is required. TOTALCARE protein remover tablets keep your lenses at their best, and allow daily disinfection and protein removal to be carried out in one simple step. After cleaning your lenses as described In the daily routine, add one TOTALCARE protein remover tablet to the lens case filled with TOTALCARE solution and close it. Allow your lenses to soak for at least 6 hours but no longer than 12 hours in the solution containing the TOTALCARE protein remover tablet. After using TOTALCARE protein remover tablets, always rub and rinse your lenses thoroughly with TOTALCARE solution before putting them into your eyes. Rinse the lens case with TOTALCARE solution and allow it to dry. PrecautionsAll instructions must be followed. Failure to do so may hall In serious eye Infection or injury. General
Use
Storage
Discard
Product Contains
|
|
For all hard and gas permeable contact lenses
TOTALCARE is a simple and convenient system for the rare of hard & gas permeable contact lenses.
The TOTALCARE system consists of the following components which may be purchased separately:
Always wash and dry your hands thoroughly before handling your contact lenses.
Remove the left lens from your eye and place on the palm of your hand. Place 2-3 drops of TOTALCARE Daily Cleaner on each lens surface and rub for 15-20 seconds with your finger. Rinse the lens thoroughly with TOTALCARE solution or sterile saline to remove all traces of cleaner.
Place the lens in the holder of the left cap (L) and close the lens case with this cap. Fill the lens case with TOTALCARE solution. Ensure that the lens case is completely filled to the top. Repeat this procedure with ; the right contact lens.
Allow your lenses to soak in TOTALCARE solution for at least 6 hours (overnight) to ensure thorough disinfection. Store the lenses ln the unopened lens case until ready to wear.
Rinse your lenses with TOTALCARE solution and insert them into your eyes. Discard used solution and rinse the lens case with TOTALCARE solution and allow to air dry.
Note: Your lenses may be stored in the unopened lens case for a maximum of 30 days. If they are stored for longer periods of time, disinfect again before inserting your lenses.
For wetting, place one or two drops of TOTALCARE solution on the inner surface of each contact lens before inserting into your eye.
Your optician will advise it protein removal Is required.
TOTALCARE protein remover tablets keep your lenses at their best, and allow daily disinfection and protein removal to be carried out in one simple step.
After cleaning your lenses as described In the daily routine, add one TOTALCARE protein remover tablet to the lens case filled with TOTALCARE solution and close it.
Allow your lenses to soak for at least 6 hours but no longer than 12 hours in the solution containing the TOTALCARE protein remover tablet.
After using TOTALCARE protein remover tablets, always rub and rinse your lenses thoroughly with TOTALCARE solution before putting them into your eyes. Rinse the lens case with TOTALCARE solution and allow it to dry.
All instructions must be followed. Failure to do so may hall In serious eye Infection or injury.
General
Use
Storage
Discard
Product Contains